Voice Recorder
Already have a recording? Drop it here, or open it from your device.
How it works
Pick your microphone and press Record. The browser's call settings — echo cancellation, noise suppression and automatic volume — are turned off, so your voice is recorded as the mic hears it.
Know if you're too soft or too loud
Press Check mic and say a couple of sentences in your normal recording voice: the meter tells you whether your level is good, and what to change if it isn't. The same meter runs while you record, and the editor reports the level of the whole recording, including files from another recorder. A soft recording can be turned up later, but the room noise comes up with it; a too-loud one has its peaks flattened, which can't be undone.
Drop a fluffed line as it happens
The recorder listens for the pauses between your lines. When you slip, press Backspace: recording pauses and everything since your last pause turns red. Press Backspace again to go back one more pause, Enter to discard the red part, or Esc to keep it. Recording carries on, and you say the line again.
Pause when something interrupts
When a noise outside cuts in, press P to pause. The whole take so far is shown: click near where the last good part ends and press Play, stop playback where it ends, and Discard after this point to drop the rest. Press P again to carry on recording from there.
Trim the rest on the waveform
When you stop, or when you open a recording you already have, drag across the waveform to mark the parts to cut. Click a marked part to remove it again. Play lets you hear the result with the cuts skipped, and Space starts and stops it.
Downloads lossless FLAC
The file you download is FLAC: mono, 24-bit, at the recording's own sample rate, with nothing lost to compression.
Nothing leaves your device
Recording, trimming and encoding all happen in your browser. Nothing is uploaded or saved, so download your file before you close the page.